BMW X 5: 3.0 door will not open. Find the answer to this and other BMW questions on JustAnswer. Mar 17, 2014 2003 Bmw X 5 4.6is Out of no where the Door at driver side from will not open anymore. Driver side front door not opening! (from inside it opens okay). BMW X5 2006 driver side window would not go up! - Sounds like its window. Doesn't unlock doors and the central locking doesn't wo. I have a bit of an issue, front passenger side door. Neither the exterior or interior door handle open the door (currently shut with no way to open). I believe the problem is with the actuator. It locks and unlocks perfectly, and when locked, pulling the interior handle once unlocks it mechanically as well. I was able to remove the door card from the inside, and feel that both lines (from exterior handle and interior handle) pull on the respective levers of the actuator mechanism successfully, so it's not the handles. (Update: solved by replacing cable inside door, see post #8 below). Sorry for misunderstanding. Locks and everything electrical works perfectly. Just the mechanical system inside the actuator which translates the pulling of 2 levers (one for interior handle, one for exterior), into the opening of the clasp which holds the door shut. Anyway, took it to BMW and had a service guy look at it. He was clueless, then pulled the lever for the interior handle (as I'd done about a hundred times), and on the 3rd or 4th try it magically popped open. Ordering replacement actuator now. I wouldn't have posted this as a new thread if it had been the lock issue, I know of the SIB and searched before posting and couldn't find anyone with the same problem. Thanks for the input regardless. Quick update, in case someone runs into this issue in the future. The door actuator mechanism (part you see with the latch in photo above) is prone to becoming stuck and unresponsive to pulling both interior+exterior door handles (at least on E53s ). This happens when the cable running from the exterior handle assembly inside the door to the door actuator mechanism (i.e. Punkbuster call of duty update. Bowden cable) is worn. When the exterior handle is pulled, the cable pulls on the lever in the door actuator, but because it is worn, the actuator lever does not go down to completion, and the door stays shut (latch doesn't pop open to release the door). The internal mechanism of the actuator does not reset back to fully-shut-door position, and subsequent pulling of either door handle, partially or to completion, has no effect on the latch (stuck shut). Lock/unlock (electronic or pulling on the interior handle once (if locked)) works perfectly. To remedy, you must feel for the lever of the actuator mechanism connected to the bowden cable and manually depress it (to completion), resetting the internal actuator mechanism and opening the door. It took some force in my case, especially at the end, near full extension. This is the lever that needs to be depressed from inside the door: More specifically: Pull seat backwards all the way (if affected door is front), raise the window all the way up. Remove horizontal trim piece and door grab handle trim piece (if pass. Remove the 3 or 4 torx screws from where the trim piece(s) covered them. With all screws removed, pull on the side/bottom of the door panel to unclip the clips holding it in.
0 Комментарии
Оставить ответ. |
АвторНапишите что-нибудь о себе. Не надо ничего особенного, просто общие данные. Архивы
Март 2019
Категории |